Contacts
Technical documentation
+38(050)353-23-39
+38(044)502-23-38
+38(050)353-23-39
+38(044)502-23-38
Pumping of abrasive media, oils, petroleum products and liquids To 350°C.
To 2 000 m³/h.
To 40 bar
Pumping out air, saturated aggressive vapors, creating a vacuum To 33 mBar.
To 30 000 m³/h.
To 33 mbar.
Pumping air, saturated aggressive vapors, creating a vacuum To 5 mBar.
To 3 500 m³/h.
To 5 mbar
Pumping of liquids with different degrees of viscosity To 80,000 Cps To 250°C.
To 250 m³/h.
To 16 bar
Pumping of food products, wine and cosmetics industry.
To 200 m³/h.
To 16 bar
Pumping of foods with high viscosity and solid particles content.
To 20 m³/h.
To 12 bar
Pumping of aggressive chemicals, acids, alkalis and explosive liquids.
To 55 m³/h.
To 34 m H2O
Designed for stationary installation with direct immersion in the tank.
To 55 m³/h.
To 34 bar
Pumping liquids with different degrees of viscosity (glues, molasses, ointments, resins).
To 900 m³/h.
To 70 bar
Meat and dairy products, bakery products, pharmaceutical and chemical products.
To 70 m³/h.
To 15 bar
Accuracy better than 1% from 10 to 100% of maximum performance.
To 4028 m³/h.
To 80 bar
Highly viscous fluids that may contain high concentrations of solids/abrasives or other substances.
To 500 m³/h.
To 24 bar
Electric or pneumatic chemical drum pump TR series
to 90 l/min.
Viscosity
to 600 cPz.
Technical documentationTR barrel pumps from DEBEM are a reliable solution for your industrial needs.
Each pump consists of a submersible pump part and a motor, which is not immersed in the liquid during operation. The pump part can be 900 or 1200 mm long.
The main advantages of the TR series pumps are their low price and the default IP 54 motor protection class (dust and splash protection). Competitors' motors with IP 54 protection class are considerably more expensive.
Barrel pumps (drum pumps) are small and especially convenient for pumping solvents, liquids from containers, including aggressive ones. Such a pump, immersed in a liquid, does not require an internal mechanical seal (which most often wears out) and its design ensures that any leakage of liquid, even accidental, will be collected in the container.
The TR barrel pump can be supplied with an electric or pneumatic motor. The open-type rotor ensures continuous pumping of clean aggressive liquids with a viscosity of to 600 cPs.
A distinctive feature of our barrel pumps is that, unlike similar pumps, they are designed without a mechanical seal, which significantly increases their reliability.
Execution options:
Appearance and internal structure of Debem TR barrel pumps
The left part of the image shows two variants of the TR drum pumps (with an electric motor and with a pneumatic motor). The right part shows the internal structure of the pump.
Drum pumps consist of a submersible pipe, at the end of which there is an impeller attached to a drive shaft connected to the pump by means of a convenient clamping ring, while the transmission is carried out by means of a gimbal couplings.
Dimensions (mm)
Operating conditions